apex'i v-afc (vtec controller). the blue computer-box-thing a lot of people use to tune their vtec motors.secret sauc002 wrote:i have no idea what you two are talkin about.
| thejdm.com v6 [2026 rebirth] https://www.thejdm.com/forum/ Print view |
|
| installing vafc???? https://www.thejdm.com/forum/viewtopic.php?f=14&t=1040 |
Page 1 of 1 |
| Author: | Jespek [ December 29, 2003 ] |
| Post subject: | installing vafc???? |
i have no trouble connecting wires and stuff like that, but i have no idea how to set up my parameters. it also mentions not to start the car without having them set or it will cuase servere engine damage. can anyone help me out with step by step instructions or just take to a shop. |
|
| Author: | munster [ December 29, 2003 ] |
| Post subject: | |
I have yet to install a vafc, but i'm sure someone here can help you out. |
|
| Author: | jdm delivery [ December 29, 2003 ] |
| Post subject: | |
i have no idea what you two are talkin about. |
|
| Author: | phan [ December 29, 2003 ] |
| Post subject: | |
apex'i v-afc (vtec controller). the blue computer-box-thing a lot of people use to tune their vtec motors. |
|
| Author: | Jespek [ December 30, 2003 ] |
| Post subject: | |
also, i read that i should install the vtm signal wire, and hear that i shouldnt. i think im going to take it to someone who is experienced with the install. thanks ya'll |
|
| Author: | miyagi [ January 27, 2004 ] |
| Post subject: | |
you can find parameters online if u look hard enough ... i'll see if i can find you some. I wouldn't drive around all day long with these parameters, as each motor is seperate and reacts differently, even though they are all made from the same place. They'll be good enough to get the car safely running until you can get it dyno'd. i'll look for some for ya |
|
| Author: | miyagi [ January 28, 2004 ] |
| Post subject: | |
actually don't the parameters go by +/- 10? If that's true, if you set everything at 0 then it's at it's stock setting, correct? I don't have any personal experience with them, but that's what i understood about them. Anyway, if that's true, set everything at 0 until u can either dyno it, or find someone who knows what they're doing with it, or find what to do through research. I'm still looking for some parameters for you - i'll keep you posted |
|
| All times are UTC-04:00 | Page 1 of 1 |
|
Powered by phpBB® Forum Software © phpBB Limited |
|