| thejdm.com v6 [2026 rebirth] https://www.thejdm.com/forum/ Print view |
|
| duckbill wing install https://www.thejdm.com/forum/viewtopic.php?f=14&t=1355 |
Page 1 of 1 |
| Author: | Hatcher [ February 02, 2004 ] |
| Post subject: | duckbill wing install |
I'm trying to take off my stock brake light spoiler so i can install a vis duckbill wing. so far i've taken out the 2 little screws where the brake light is and the 2 nuts underneath in the door jam... what do I do next? thanks |
|
| Author: | .saint [ February 03, 2004 ] |
| Post subject: | |
open the hatch and look in the center there should be a black plug. take that plug out and there is a bolt hiding under there. undo that bolt and the rest of the bolts. and it will pop right off. |
|
| Author: | tenchu [ February 03, 2004 ] |
| Post subject: | |
and dont forget to post pictures when complete |
|
| Author: | iron monky [ February 03, 2004 ] |
| Post subject: | |
to install a duck bill wing you need to a.disconnect yur factory tail light b.undo the water plugg c.pull of the upper center panel and reviel 2 bolts d.unscrew the outer bolts...in total there are only 4 bolts e. remove and place yur new duckbill on yur car |
|
| Author: | BRYCE [ February 03, 2004 ] |
| Post subject: | |
f. sport it around town |
|
| Author: | Hatcher [ February 04, 2004 ] |
| Post subject: | |
well I got it installed and the fitment turned out to be good. But now I have a couple more questions... I installed it like I said but I didnt disconnect my tail light to do it, and I didnt do anything with that plug that john mentioned. all I did was wrap electrical tape around that wire thing that goes into the little tube. and off to the right there's that little wire plug harness I diconnected that when I took off the stock one and I wrapped that in electrical tape. Is there anything I should've done differently? |
|
| Author: | iron monky [ February 04, 2004 ] |
| Post subject: | |
as long as u wrapped the wires up and there not exposued then you shoul be ok man |
|
| Author: | Hatcher [ March 15, 2004 ] |
| Post subject: | |
next step... get a real spoon tail. I've learned my lesson with this fake shit. VIS wings suck, my friends hood has a 1/2 inch gap above his right side headlight too, I think I'll only get their c/f hatch and that's it. |
|
| All times are UTC-04:00 | Page 1 of 1 |
|
Powered by phpBB® Forum Software © phpBB Limited |
|