| thejdm.com v6 [2026 rebirth] https://www.thejdm.com/forum/ Print view |
|
| wireing vtec in a 97 dx hatch https://www.thejdm.com/forum/viewtopic.php?f=14&t=6322 |
Page 1 of 1 |
| Author: | vtjdmsir [ May 27, 2006 ] |
| Post subject: | wireing vtec in a 97 dx hatch |
I have a b16a1 and i have the wireing harness ecu from the b16 and my cars stock wiring harness. Im getting a od1 to obd2 harness just wondering what is the easest way to wire vtec and the best way of doing it Thanks James |
|
| Author: | munster [ May 27, 2006 ] |
| Post subject: | |
Get your pinout for the obd1 ecu and run the necessary wires from the bay into the harness and pin them where they need to be. http://www.ff-squad.com/tech/wiring/wiring.96-98.jpg http://www.ff-squad.com/tech/wiring/wiring.92-95.jpg |
|
| Author: | vtjdmsir [ May 28, 2006 ] |
| Post subject: | |
do i use the b16 harness or my stock harness |
|
| Author: | munster [ May 28, 2006 ] |
| Post subject: | |
Use your stock harness and add the vtec wiring. Obd1 harnesses are on both sides of the bay. obd2 has one cluster of plugs. Is it an obd1 motor too? |
|
| Author: | vtjdmsir [ May 28, 2006 ] |
| Post subject: | |
yeah its a b16a1 obd1 |
|
| Author: | munster [ May 28, 2006 ] |
| Post subject: | |
Ok. Use your stock harness. You're going to have to splice the injector wires and switch some wires. You'll also have to lengthen alot of wires. There's alot of plugs that you have to splice because the obd1 has round plugs on some sensors. You're also going to have use obd2 distributor guts so the plugs match unless you feel like splicing everything. Then you can plug in the jumper harness and run the obd1 distributor. Good luck. It was a long time since I did mine, but just take your time. |
|
| Author: | vtjdmsir [ May 29, 2006 ] |
| Post subject: | |
i got a brand new dizzy with the motor so to use the obd1 dizzy i whould have to use my obd1 ecu with the jumper harness |
|
| Author: | munster [ May 29, 2006 ] |
| Post subject: | |
To use the obd1 distributor guts you have to cut the dizzy plug off of the obd2 harness and splice into the obd1 plug. The main reason you have to cut and splice are different plugs and the wiring harness being too short. |
|
| All times are UTC-04:00 | Page 1 of 1 |
|
Powered by phpBB® Forum Software © phpBB Limited |
|
