| thejdm.com v6 [2026 rebirth] https://www.thejdm.com/forum/ Print view |
|
| Intake fitment https://www.thejdm.com/forum/viewtopic.php?f=14&t=6465 |
Page 1 of 1 |
| Author: | hondalover [ June 14, 2006 ] |
| Post subject: | Intake fitment |
I was just wondering my buddy isnt using his aem intake anymore since he has got his turbo, and was wondering if it would fit my ek. He has a eg with a ls motor i wanna use his intake on my ek with a b16 motor. |
|
| Author: | kotomile [ June 14, 2006 ] |
| Post subject: | |
I used a CTR intake on my CRX, you could probably make it fit.. |
|
| Author: | ef8 mcm [ June 15, 2006 ] |
| Post subject: | |
i dont see why it wouldnt fit. |
|
| Author: | btec [ July 05, 2006 ] |
| Post subject: | |
well my friend had a passwordjdm intake for his eg and he gave it to me and i have a em1 and it fit fine. i'm pretty sure it will fit. correct me if i'm wrong, but for intakes, all civics are generally the same, fitment wise?? |
|
| Author: | hondalover [ July 05, 2006 ] |
| Post subject: | |
Well it doesnt fit i found out yesterday when putting my motor in, cause of it being a cold air and it goes down in behind the front bumper it doesnt fit. There is no hole there like on the eg for it to route threw. SO i just have to cut it off and make it a shorter version. |
|
| Author: | kotomile [ July 05, 2006 ] |
| Post subject: | |
There didn't USED TO be a hole in my CRX to fit an EK9's V2 in there but a 4" holesaw and a day's work later it fit like a glove. |
|
| All times are UTC-04:00 | Page 1 of 1 |
|
Powered by phpBB® Forum Software © phpBB Limited |
|