| thejdm.com v6 [2026 rebirth] https://www.thejdm.com/forum/ Print view |
|
| JDM Civic Type R Climate Controls? https://www.thejdm.com/forum/viewtopic.php?f=14&t=8106 |
Page 1 of 1 |
| Author: | JaySmith [ March 24, 2007 ] |
| Post subject: | JDM Civic Type R Climate Controls? |
Would anyone happen to have an easier method of trimming back the passenger side vent to make clearance for the '99-'00 JDM Honda Civic Type R Climate Controls? Or even some photographs of how much vent I'm actually suppose to trim? lol Such a fucking pain in the ass.... |
|
| Author: | .saint [ March 25, 2007 ] |
| Post subject: | |
i just started hacking. they will never line up, so i had nothing to loose when cutting. i used a dremel with a round sanding bit and went to town. |
|
| Author: | JaySmith [ March 25, 2007 ] |
| Post subject: | |
I figured as much. lol Do you by chance have any photographs of what you cut away? And is this item secured with the reused bolts, or will it unfortunately just be sitting in there? |
|
| Author: | .saint [ March 25, 2007 ] |
| Post subject: | |
mine just sits there  there is also a little piece of metal that needs to be trimmed away on the right hand side... where the CTR climate controls are located it bumps a piece of metal. you might be able to try and bolt it up. i never tried mine fits pretty snug. if i had a camera i would snap some pics for ya. but i dont have one at the moment. ill see what i can do for ya though. |
|
| Author: | JaySmith [ March 25, 2007 ] |
| Post subject: | |
Yea I'm going to try, and make it so that it's atleast some what secured with the OEM bolts, however it's probably easier said then done unfortunately. |
|
| Author: | .saint [ March 25, 2007 ] |
| Post subject: | |
i had no idea what i was doing when i started tearing into mine. that was a good 4 years ago. good luck on the project its not a hard thing to do. |
|
| All times are UTC-04:00 | Page 1 of 1 |
|
Powered by phpBB® Forum Software © phpBB Limited |
|