| thejdm.com v6 [2026 rebirth] https://www.thejdm.com/forum/ Print view |
|
| bleeder help https://www.thejdm.com/forum/viewtopic.php?f=15&t=2320 |
Page 1 of 1 |
| Author: | Bangin HB [ October 19, 2004 ] |
| Post subject: | bleeder help |
anyone know the size of the bleeders on a 5th gen? 92dx hatch if needed. my MC went out, and im away from home so i dont have access to my usuall tools. so i need to go buy some for the job, and i need to know the size of the bleeder screws |
|
| Author: | BRYCE [ October 19, 2004 ] |
| Post subject: | |
most likey 8mm or 10mm. Most likey 8 though |
|
| Author: | SleepyCx [ October 27, 2004 ] |
| Post subject: | |
clutch or brake clutch both are 8's except for some reason my back brakes are 10's because i have swapped rear disk brakes... |
|
| Author: | Bangin HB [ October 27, 2004 ] |
| Post subject: | |
oops, job done. anyone curious tho about doing a brake job: 12mm to take the MC off the booster; 10mm flare-nut wrench for the hard lines to the MC; 8mm for the drum bleeders; 10mm for the caliper bleeders. and if you get stuck like me, 19mm socket with a breaker bar for the wheels (damn tire iron wouldnt fit!) |
|
| All times are UTC-04:00 | Page 1 of 1 |
|
Powered by phpBB® Forum Software © phpBB Limited |
|