those numbers seem pretty low for being modded.....
vtec
| thejdm.com v6 [2026 rebirth] https://www.thejdm.com/forum/ Print view |
|
| 1st time at the dyno https://www.thejdm.com/forum/viewtopic.php?f=15&t=73 |
Page 1 of 3 |
| Author: | SikofFalln [ March 18, 2003 ] |
| Post subject: | 1st time at the dyno |
hit 125.3hp and 95.4tq at 7200rpm. This was with a B16A2 with a hiper exhaust, race cat, AEM cold air, and a DC 4-1 header while running on a stock unchipped P28. It was better then I thought it would be with the ECU being stock and all. My A/F is really shitty before it hits V-tech. |
|
| Author: | domoMKIV [ March 18, 2003 ] |
| Post subject: | |
those numbers seem pretty low for being modded..... vtec |
|
| Author: | SikofFalln [ March 18, 2003 ] |
| Post subject: | |
Modded yes, but running a stock SOHC ecu on a B16. |
|
| Author: | MagillaGorilla [ August 07, 2003 ] |
| Post subject: | |
Get your AFR straightened out and you will make a bit more hp/ft. Or buy a LS block, yummm.  |
|
| Author: | mugen85r [ August 07, 2003 ] |
| Post subject: | |
b16a2 makes 160 @7600 rpm so if you put in the b-series ECU for this engine, what numbers do you think you'll get??? that's a pretty big loss at the wheel for the SOHC ECU |
|
| Author: | MagillaGorilla [ August 07, 2003 ] |
| Post subject: | |
Thats at the flywheel. You lose so much Hpgoing thorugh the drivetrain and wheels its crazy. Iv seen wrose numbers come from a b16 so atleast hes doin somethign right haha.  |
|
| Author: | munster [ August 07, 2003 ] |
| Post subject: | |
Does anyone know what the hp difference would be if he ran a GSR ECU? |
|
| Author: | MagillaGorilla [ August 07, 2003 ] |
| Post subject: | |
It wouldnt be too much. Maybe 5-10 HP max, the Vtec crossover is probably lower too. |
|
| Author: | Turbogixxer [ August 07, 2003 ] |
| Post subject: | |
I think that you will gain more (than people think) by a chipped p28, or a p30, p72. You car is probaby running lean. BTW did you scan the dyno sheet? |
|
| Author: | sal_blkej2 [ August 08, 2003 ] |
| Post subject: | |
wrd, get your p28 chipped then dyno it to see exactly how much you gain...i'm interested to know cuz i have a friend with the same mods as you except he has the skunk2 chip on his p28...lmk and good luck |
|
| All times are UTC-04:00 | Page 1 of 3 |
|
Powered by phpBB® Forum Software © phpBB Limited |
|