tach

90hatch · Post by **90hatch** » August 06, 2004

im puttin in a tach and i dont know where to plug the last and most important wire in. i dont have a external coil. i have the electronic ignition so where do i plug that last wire in?

Post by **BRYCE** » August 06, 2004

Mabye you should post this in the Ef section, but i know in the eg's there is a blue signal wire under the hood, the back passenger side. I dont know if it is the same in a ef. and i am assuming a ef because of your name.

phan · Post by **phan** » August 10, 2004

ok, i don't quite understand what you're saying. just answer me this: what wire (from the tach) has NOT been hooked up yet?

Post by **Nikku** » August 10, 2004

buy my gauge cluster......problem solved

ed9 · Post by **ed9** » October 07, 2004

Tach lead?? you could directly connect to the wire to the green/white lookin wire stickin out of the dizzy,(the plug where there is only two wires).....im assuming your talking about an aftermarket tach,otherwise im confused...

phan · Post by **phan** » October 08, 2004

ah, so you've already hooked power and ground up? just trace the wire to the signal as ed9 said...but i'd run the wire to the ECU, rather than the dizzy itself...makes it easier and looks cleaner.