building a rhd crx ?

ef8 mcm · Post by **ef8 mcm** » February 11, 2006

munster wrote:
vtjdmsir wrote:whats so unsafe about them if ever thing is there, and my cuzin is a welder.
I saw a H22 fifth gen with a front clip done and it was a horrible job. If your cousin is a welder and you're able to keep everything straight then go for it. Just remember that it is a halfed car. Take the extra precautions.

that was at carlisle right? it was white? if thats the one the front had sheet metal screws in it.

munster · Post by **munster** » February 11, 2006

ef8 mcm wrote:
munster wrote:
vtjdmsir wrote:whats so unsafe about them if ever thing is there, and my cuzin is a welder.
I saw a H22 fifth gen with a front clip done and it was a horrible job. If your cousin is a welder and you're able to keep everything straight then go for it. Just remember that it is a halfed car. Take the extra precautions.
that was at carlisle right? it was white? if thats the one the front had sheet metal screws in it.

Yeah it was in Harrisburg. It sucked horribly.

prohonda16 · Post by **prohonda16** » February 28, 2006

i would think the proper way to do it would be to piece in the fire wall. if you look at the walls they are symetrical. that would seem to be the best way to do it with out comprimiseing safety.....just a thought
steve

upcominjdmef · Post by **upcominjdmef** » February 28, 2006

a good welder and a chassie machine to make sure things are streight thast it man dont get scared from people and their comments i did on and i am doing another right now oh also i did 6 point roll cage in my crx tho but everything came out great goodluck