thejdm.com v6 [2026 rebirth]
https://www.thejdm.com/forum/
Print view

header question
https://www.thejdm.com/forum/viewtopic.php?f=17&t=6453		 Page 1 of 2
Author:  01teggy [ June 12, 2006 ]
Post subject:  header question
does anybody know of anyone who has tried the blox header? if so is it similar to the skunk header? any complaints or compliments about the blox header would help. :?
Author:  vtecdood [ June 13, 2006 ]
Post subject: 
I know the blox intake is an exact copy of the skunk looks like they are from the same cast literally so my guess would be this is true for the header as well. Blox has good quality
Author:  Sean @ NDF [ June 13, 2006 ]
Post subject: 
I'm with vtecdoodoo on this one
Author:  .saint [ June 13, 2006 ]
Post subject: 
skunk2 was modeled after the ITR header so... save money and get oe ITR.
Author:  vtecdood [ June 13, 2006 ]
Post subject: 
banzai wrote:I'm with vtecdoodoo on this one

you calling me a piece of crap? :x
Author:  vtecdood [ June 13, 2006 ]
Post subject: 
.saint wrote:skunk2 was modeled after the ITR header so... save money and get oe ITR.
not to upset you but there really is not difference in type r to skunk or blox save the money go with the blox unless you are a jdm whore and need the Hype R factor :bang:
Author:  01teggy [ June 13, 2006 ]
Post subject: 
cool thanks guys!! :)

so any of you guys know anyone who tried the blox intake manifold? i heard it made good power but then you cant believe everything you hear, ya know
Author:  Sean @ NDF [ June 13, 2006 ]
Post subject: 
vtecdood wrote:
banzai wrote:I'm with vtecdoodoo on this one

you calling me a piece of crap? :x
hahaha nah, jk
Author:  vtecdood [ June 14, 2006 ]
Post subject: 
01teggy wrote:cool thanks guys!! :)

so any of you guys know anyone who tried the blox intake manifold? i heard it made good power but then you cant believe everything you hear, ya know
If you are running a stock GSR manifold then you will see significant increase, with stock a LS or B16 not that much gain N/A, turbo depends on boost pressure 10psi or lower now anything higher than 10 id recomend it then or with an all motor build that has increased compression.
Author:  Sean @ NDF [ June 14, 2006 ]
Post subject: 
anyone wanna move this to engine tech?
All times are UTC-04:00 Page 1 of 2

Powered by phpBB® Forum Software © phpBB Limited