| thejdm.com v6 [2026 rebirth] https://www.thejdm.com/forum/ Print view |
|
| 96 civic cx engine swap to b18 wiring question about harness https://www.thejdm.com/forum/viewtopic.php?f=17&t=6850 |
Page 1 of 1 |
| Author: | IN2deep [ August 04, 2006 ] |
| Post subject: | 96 civic cx engine swap to b18 wiring question about harness |
ok i have a 96 cx hatch that im going to put a b18 in ive finally made my mind up on motor choice after going back and forth several times, i was planning on buying a 99-00 civic si harness to make it plug and play- i think i may have to lengthen a wire or two but that should be it, i am looking at swapping in a 97-97 b18c5 or a 94-97 b18c1 i think a GSR is a c1 anyway should i go with the 99-00 civic si harness or this rywire connector for my harness i have on my motor http://rywire.com/store/9600-civic-dxlx ... 21a1659736 or post a suggestion, i was thinking it was better to go with the SI harness opinions and thoughts welcomed |
|
| Author: | kotomile [ August 04, 2006 ] |
| Post subject: | |
If you go with the C1 don't forget the dual length IM wire. |
|
| Author: | IN2deep [ August 04, 2006 ] |
| Post subject: | |
dual length IM wire? explain a little more please |
|
| Author: | kotomile [ August 04, 2006 ] |
| Post subject: | |
the GSR has a dual-butterfly intake manifold, so that part won't function with a Si harness. |
|
| Author: | munster [ August 04, 2006 ] |
| Post subject: | |
If you have a 96 CX a 99-00 SI harness won't work. Different plugs. obd2a vs. obd2b. The plugs at the ecu are different. You'd have to get a jumper harness. Just use your stock harness and add the necessary wires. 96-98 pinout: http://www.ff-squad.com/tech/wiring/wiring.96-98.jpg 99-01 pinout: http://www.ff-squad.com/tech/wiring/wiring.99-01.jpg |
|
| Author: | IN2deep [ August 05, 2006 ] |
| Post subject: | |
so use my harness and get the rywired harness or just wire it myself? thanks i was about to buy a harness so u guys saved my a$! thanks |
|
| Author: | munster [ August 05, 2006 ] |
| Post subject: | |
I would just use your stock harness. Add the necessary wires. no need to buy a whole rywire harness. Just get an obd2 to obd1 jumper harness if you're running an obd1 ecu. |
|
| All times are UTC-04:00 | Page 1 of 1 |
|
Powered by phpBB® Forum Software © phpBB Limited |
|
