this has nothing to do with your stud topic, but who did you buy the volks from? i traded mine awhile back and from what i understand, the guy i traded with is a real wheel whore.
| thejdm.com v6 [2026 rebirth] https://www.thejdm.com/forum/ Print view |
|
| extended wheel studs install https://www.thejdm.com/forum/viewtopic.php?f=20&t=1535 |
Page 1 of 2 |
| Author: | Hatcher [ March 05, 2004 ] |
| Post subject: | extended wheel studs install |
I just bought some extended wheel studs and want to install them. I was told I would need a 32mm axle socket and chisles, will I need anything else? also how long would you say this install takes? any advice for doing the fronts? I dont have rear brakes so the backs shouldnt be hard. I just bought some black volk GR-NRS's so I want to put those bad boy's on. thanks |
|
| Author: | phan [ March 05, 2004 ] |
| Post subject: | |
this has nothing to do with your stud topic, but who did you buy the volks from? i traded mine awhile back and from what i understand, the guy i traded with is a real wheel whore. |
|
| Author: | kotomile [ March 05, 2004 ] |
| Post subject: | |
I've replaced a few wheel studs on several different cars, never had to loosen the axle nut or touch a chisel. I just drive out the old one with a hammer and pull the new one through with a lugnut, simple as that, let us know how it turns out, I may have to do this soon... |
|
| Author: | munster [ March 05, 2004 ] |
| Post subject: | |
Just get yourself a B.F.H and beat on the old ones like koto said. One question...you got extended studs for the rear too? |
|
| Author: | Hatcher [ March 06, 2004 ] |
| Post subject: | |
I bought them off of a guy that works at inlinefour. They were on simple green's EG on http://www.tunedhonda.com you can see them |
|
| Author: | Hatcher [ March 06, 2004 ] |
| Post subject: | |
well I'm going to install them tomarow. I'll try to hammer them out, we'll see how it goes. thanks |
|
| Author: | munster [ March 06, 2004 ] |
| Post subject: | |
Simple Green is a member here too. *off topic* |
|
| Author: | Hatcher [ March 06, 2004 ] |
| Post subject: | |
how do I get the hub off? do I just pry it off with a screw driver and hammer? |
|
| Author: | kotomile [ March 06, 2004 ] |
| Post subject: | |
Don't take it off, just drive the studs out on the car. It's easy. |
|
| Author: | munster [ March 06, 2004 ] |
| Post subject: | |
If you can get the studs out with it on the car that's so damn easy. If you'd take the hub assembly off then you'd have all of the balljoints to contend with, etc. it would move around when you're trying to hit it, etc. |
|
| All times are UTC-04:00 | Page 1 of 2 |
|
Powered by phpBB® Forum Software © phpBB Limited |
|