| thejdm.com v6 [2026 rebirth] https://www.thejdm.com/forum/ Print view |
|
| Spoon tower bars. https://www.thejdm.com/forum/viewtopic.php?f=20&t=1691 |
Page 1 of 2 |
| Author: | jdm delivery [ April 15, 2004 ] |
| Post subject: | Spoon tower bars. |
i was considering buying some Spoon tower bars. has anyone heard anything about them good/bad will the work in a coupe? thanks.. |
|
| Author: | kotomile [ April 15, 2004 ] |
| Post subject: | |
EG coupe? EK coupe? If they work in a hatch, I think they should work fine in the coupe. |
|
| Author: | jdm delivery [ April 15, 2004 ] |
| Post subject: | |
ek coupe. |
|
| Author: | BRYCE [ April 15, 2004 ] |
| Post subject: | |
I would imagen they rank up there pretty high. I doubt spoon would make a shitty product. |
|
| Author: | blingin' civic [ April 16, 2004 ] |
| Post subject: | |
why dont you just get the Skunk2 ones and save a little cash. They are practically the same thing. |
|
| Author: | kotomile [ April 16, 2004 ] |
| Post subject: | |
Good call. Skunk2 walks all over Spoon IMO. S2 is Spoon without the JDM bling. |
|
| Author: | jdm delivery [ April 17, 2004 ] |
| Post subject: | |
good point. |
|
| Author: | BRYCE [ April 17, 2004 ] |
| Post subject: | |
ha S2 is to USDM as Spoop is to JDM |
|
| Author: | jdmwagon [ April 17, 2004 ] |
| Post subject: | |
the Spoon stuff is good. I have the tie bars and I like them. All out JDM=Spoon I don't give a fawk I rock what's easy=Skunk 2 |
|
| Author: | Bart-EK [ April 17, 2004 ] |
| Post subject: | |
Sporting the Spoon stuff on my EF... Used to have shitty TenzoR crap... let me put it this way: putting the spoon ON was easier and better fitting, than the taking the Tenzo OFF... SICK... the spoon just slid over the threads and I was done in 10 secs or so... No other BS about tightening anything else, because it's made universal or that crap... just 100% JDM precision fitment!!! |
|
| All times are UTC-04:00 | Page 1 of 2 |
|
Powered by phpBB® Forum Software © phpBB Limited |
|