Hoping to get this thing up to beaver run this summer to see how the handling improvements. I also added the 2.5" stainless exhaust w/ 2.5" stainless cat and modified the edelbrock header by putting a 2.5" collector on it the exhaust sounds so good.
| thejdm.com v6 [2026 rebirth] https://www.thejdm.com/forum/ Print view |
|
| New parts for the integra https://www.thejdm.com/forum/viewtopic.php?f=27&t=9884 |
Page 1 of 1 |
| Author: | vtecdood [ April 30, 2008 ] |
| Post subject: | New parts for the integra |
Hoping to get this thing up to beaver run this summer to see how the handling improvements. I also added the 2.5" stainless exhaust w/ 2.5" stainless cat and modified the edelbrock header by putting a 2.5" collector on it the exhaust sounds so good.
|
|
| Author: | Colin [ April 30, 2008 ] |
| Post subject: | |
 |
|
| Author: | munster [ April 30, 2008 ] |
| Post subject: | |
The teg is turning into quite the project car. haha. |
|
| Author: | boostjunkie95 [ April 30, 2008 ] |
| Post subject: | |
Looking good. I bet she handles like mad.  |
|
| Author: | vtecdood [ May 01, 2008 ] |
| Post subject: | |
Ye I have always wanted an integra with a jdm front often thought of getting rid of the civic for one. So now that I got one I am doing a little to it to make it fun. I got a new steering wheel on the way for it then it is done up to beaver run it is going  |
|
| Author: | tomoyasu [ May 01, 2008 ] |
| Post subject: | |
JDM front FTW nice car |
|
| All times are UTC-04:00 | Page 1 of 1 |
|
Powered by phpBB® Forum Software © phpBB Limited |
|