Thought I'd post pics of my ep3 here

Post by **tenchu** » August 05, 2005

Thats pure sex man, stick around and keep us posted on updates!

02SilverSiHB · Post by **02SilverSiHB** » August 05, 2005

here's the results from the dyno...the vid shows the lower number before he finished...I'm the bald head you see pass by..the guy driving in the other vid is in a s2000 going after me...I get around a couple of cars and see I finally can stomp it...and waste him

Hehehehee I bet Jose's on here to maybe...he's cool!

vids:
http://home.comcast.net/~jvortizjr/Mikeownage.wmv

http://home.comcast.net/~jvortizjr/MikeDyno.wmv

I went up to Velocity in Carrollton, Texas (near Dallas).
And before a few ask...it cost me 300 for tuning...not bad imo!

Stoney did an awesome job again! I'm only running 7.5 psi at most. I was running pretty crappy since I put the new manifold on...leaning out a lot.

So from the start...it was only 230whp

I was like damn...I was shooting for 260-270whp after tuning, but after that I didn't think it was possible.

Anyway, Stoney not only met my expectations...but went beyond. He ended up with 284whp and 194 tq. And that was with a lot of timing taken out for added safety...Stoney knows now how much of a lead foot I have

I know, it's not as much as my a3...but my a3 was running a tad better kit and 10psi. This Turbonetics turbo isn't as torquey as my last sc34...but that's okay. It's easier to launch for racing...but not as quick to spool. With the a3, I only had 267whp with the 7.5psi...but I had more torque 225 with the 7psi. So as you can see...not as torquey.

Pics of the dyno and more pics of the great shop. thanks to Stoney again!

Base line dyno with after tuning...noticed how he cut a tad short on the base one...it was leaning out in a few spots..especially under partial throttle

Here it is by itself...just about as perfect a/f ratio as you can get

some other cars...a few vipers, g35 in the works for boost, etc

Post by **Sean @ NDF** » August 05, 2005

nice numbers

02SilverSiHB · Post by **02SilverSiHB** » August 19, 2005

I just bought some new wheels...Work RSZ-R in 16" silver. I'm still waiting on honda to get my clutch working...it's install, but not going in gear. The ACT High pressure plate isn't letting the push rod extend far enough..it's been in there for a damn week. I'm so sick of it.

anyway, a pic of the wheels...can't wait to put these bad boys on

VtecVixen · Post by **VtecVixen** » August 19, 2005

nice EP!!!

ls.pwrd.hb. · Post by **ls.pwrd.hb.** » August 20, 2005

looks good man, good to see a boosted k block on here, keep it up, i wanna see what those wheels are going to look like, good numbers too, what kinda tires you going with

02SilverSiHB · Post by **02SilverSiHB** » August 21, 2005

I'll be using the falken azenis that I currently have..still some tread left

Post by **Sean @ NDF** » August 21, 2005

dude, those wheels will look prime on your car. good choice

ls.pwrd.hb. · Post by **ls.pwrd.hb.** » August 22, 2005

i have azenis as well you like the way they perform?