thejdm.com v6 [2026 rebirth]
https://www.thejdm.com/forum/
Print view

Betty: 2012
https://www.thejdm.com/forum/viewtopic.php?f=31&t=11113		 Page 1 of 5
Author:  munster [ January 19, 2012 ]
Post subject:  Betty: 2012
Finally got some garage time. New setup is finally going together.

Here's a pic of the test fit:
Image
Turbo isn't clocked in the pic. Now to pull everything back out so the bay can get painted. Traction bar and misc parts ordered this week. When the chassis comes back the powdercoated and polished parts should be done. Wastegate tube is being rotated so I have more room.
Author:  77 [ January 19, 2012 ]
Post subject:  Re: Betty: 2012
Saw that on facebook, super impressive.
Author:  .saint [ January 19, 2012 ]
Post subject:  Re: Betty: 2012
nice. looks proper with a K in there.
Author:  Zero [ January 19, 2012 ]
Post subject:  Re: Betty: 2012
sweet
Author:  munster [ January 20, 2012 ]
Post subject:  Re: Betty: 2012
Harness routing is my next hurdle. Remove loom and run across valve cover or across the rear mount and along subframe is my dilemma.

Turbo blanket is a necessity as well. Brake fluid will boil without it. It's like an SR20 with a big turbo.

I have alot of cleaning to do on the block too. Dammit.
Author:  77 [ January 20, 2012 ]
Post subject:  Re: Betty: 2012
munster wrote:Turbo blanket is a necessity as well.
Which are you going with?
Author:  munster [ January 20, 2012 ]
Post subject:  Re: Betty: 2012
Leaning towards PTP. Unless Go Autoworks has one that fits my turbine.
Author:  ap_red97ek [ January 22, 2012 ]
Post subject:  Re: Betty: 2012
This is exciting!
Author:  munster [ January 23, 2012 ]
Post subject:  Re: Betty: 2012
K-tuned traction bar, rad hoses, shifter plate, and heater hose shit en route from the frozen north.

Scuffing the bay this week and masking off. Then into the trailer she goes.
Author:  Teaks92HB [ January 24, 2012 ]
Post subject:  Re: Betty: 2012
ahhhhhhhhhh-mazing!!!!!
All times are UTC-04:00 Page 1 of 5

Powered by phpBB® Forum Software © phpBB Limited