| thejdm.com v6 [2026 rebirth] https://www.thejdm.com/forum/ Print view |
|
| SI cd player install https://www.thejdm.com/forum/viewtopic.php?f=46&t=184 |
Page 1 of 1 |
| Author: | Hatcher [ July 16, 2003 ] |
| Post subject: | SI cd player install |
can somebody please list the steps on how to install a 99-00 si cd player? traded in my hatch for another and now all i have is a damn cubby hole with a radio above it, my other ek atleast had a tape deck and it was 2 years older. hope you can help |
|
| Author: | ej8 chico [ July 16, 2003 ] |
| Post subject: | |
talk to fone |
|
| Author: | .saint [ July 17, 2003 ] |
| Post subject: | |
where do you want to mount it? up top in the climate controls or below near the shifter. |
|
| Author: | Hatcher [ July 18, 2003 ] |
| Post subject: | |
I wanna mount it where my radio is now (up top, above the cubby hole) I'm just not sure how to get my climate control off, I tried but it seemed like it would've broke if I kept trying. And I know I have to punch in the code to activate it but I'm not quite sure how. Just ordered the cd player on ebay for 58 bucks plus shipping so $74... and the dealer wanted $772. for it!!!! can you believe that!!! |
|
| Author: | .saint [ July 18, 2003 ] |
| Post subject: | |
i got mine for 55 shipped. good find none the less. you need to pull the bottom part of the dash off. the left piece on the driver side then the middle piece. (you might need to pull the whole center console out from the shifter back to the ebrake because its a bastard to wiggle the middle piece out sometimes.. try to wiggle it out before u start taking all that apart) open up the glovebox and there is 2 screws in there holding the center piece + 2 screws up near the ACC socket and 2 under the driver side panel... taking the driver panel off there is a screw up near the switch location thing on the left side. there is a screw down below that under the dash and two on the right side near the center piece. after you have those pieces out look up under the climate controls and you will see 2 bolts holding it in.. unscrew those and slowly pry. there are clips holding the top in place. after thats out install the cd player and put it all back together... (when your prying on the climate controls BE CAREFULL! i dont remember if there is any more screws i dont think there is BUT i could be wrong its been some time since i fucked with all that. hope that helped. |
|
| Author: | Hatcher [ July 18, 2003 ] |
| Post subject: | |
hell yea that helped, thanks man... just one more question... Do I have to do any wire saudering/soldering (sp)? What causes cd players to skip when you go over bumps, is it because the wires arn't saudered/soldered (sp) together correctly? |
|
| Author: | .saint [ July 18, 2003 ] |
| Post subject: | |
no it skips cause it throws the laser off. u dont need to soder nothing. |
|
| All times are UTC-04:00 | Page 1 of 1 |
|
Powered by phpBB® Forum Software © phpBB Limited |
|