| thejdm.com v6 [2026 rebirth] https://www.thejdm.com/forum/ Print view |
|
| D-Series Teg?? https://www.thejdm.com/forum/viewtopic.php?f=52&t=10872 |
Page 1 of 1 |
| Author: | tenchu [ August 13, 2010 ] |
| Post subject: | D-Series Teg?? |
If I recall correctly, there was a guy on here a few years ago that took the motor out of his GSR to put in his EG, then took the D-series and put it in his teg... Anyone have contact with him? A local guy is trying to put a d-series in his Teg and is requesting some help  |
|
| Author: | Teaks92HB [ August 17, 2010 ] |
| Post subject: | Re: D-Series Teg?? |
out and in...lol |
|
| Author: | tenchu [ August 17, 2010 ] |
| Post subject: | Re: D-Series Teg?? |
Lol but mounts? Linkage? Etc |
|
| Author: | DA 9_Chinga [ August 19, 2010 ] |
| Post subject: | Re: D-Series Teg?? |
i think i remember this but i also haven't been on here in like a year! lol |
|
| Author: | Zero [ August 19, 2010 ] |
| Post subject: | Re: D-Series Teg?? |
last time i checked isnt the linkage the same between B and D? if not then just use the D series linkage and try the D series mounts. |
|
| Author: | munster [ August 19, 2010 ] |
| Post subject: | Re: D-Series Teg?? |
Never did it, but have seen it finished. Use EG dseries mounts. Use the dseries linkage and axles. |
|
| Author: | Jams_ek [ August 19, 2010 ] |
| Post subject: | Re: D-Series Teg?? |
^^^ word the man is correct |
|
| Author: | tenchu [ August 21, 2010 ] |
| Post subject: | Re: D-Series Teg?? |
thanks Justin |
|
| All times are UTC-04:00 | Page 1 of 1 |
|
Powered by phpBB® Forum Software © phpBB Limited |
|