thejdm.com v6 [2026 rebirth]
https://www.thejdm.com/forum/
Print view

crower 63403 cams installed
https://www.thejdm.com/forum/viewtopic.php?f=52&t=3913		 Page 1 of 1
Author:  Hercules [ May 17, 2005 ]
Post subject:  crower 63403 cams installed
well i know i shouldnt have but i put those badboys in today with stock valve train and cam gears..haha but i couldnt get her started all day i had no idea why. cause i talked to a guy the ran them with stock everything and his ran fine with stock timing and everything and i couldnt figure it out. so i'm layin in bed pissed off thinkin bout it and thought about the valve lash, thats right i didnt touch that so its like 1am but i go outside and loosin all of those bitches and finally got it started. it runs very horrible and idles like a big hammer, my timing was screw up earlier so i'm hopin that i didnt fuck my valves up, i'm gonna run a compression tester tomorrow, hopefully that goes well. but if anyone has any idea's on how to get her running OK as far as timing or whatever i can do would be greatly appreciated... :?
Author:  Hercules [ May 17, 2005 ]
Post subject: 
anybody?! i readjusted my timing its perfect...redid the valve lash its good...but still runs like ass, it sounds like one of my plug wires is disconnected,like a lawn mower or somthin. could it be my valves bent? i havent tested the compression yet
Author:  civicex2g [ May 17, 2005 ]
Post subject: 
probably need to tune it?
Author:  BRYCE [ May 17, 2005 ]
Post subject: 
thats what i was thinkin possilby too much air for the amount of fuel??
Author:  Hercules [ May 20, 2005 ]
Post subject: 
alright just to keep you guys updated i bought a compression tester yesterday and i did bend the valves on cylinder 4. but luckily i got a new head thanks to b20rex.. but before i put her back together i'm orderin supertech valve springs so it should be bling!
Author:  civicex2g [ May 20, 2005 ]
Post subject: 
are you doing the whole head? or just the springs? just go for broke lol
Author:  Hercules [ May 21, 2005 ]
Post subject: 
i pulled an all nighter last night (friday) and swapped head's along with the 403's again and she runs perfect with stock valvetrain and i reused a headgasket, lmao. dont worry i'm orderin valvesprings on monday. then i'll have to get it tuned cuz it pretty much feels the same. i'll post some pics up here in a few days of the huge lobes :D
All times are UTC-04:00 Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited