Nope no template with the ALEX bar.
I cry now.| thejdm.com v6 [2026 rebirth] https://www.thejdm.com/forum/ Print view |
|
| Where To Cut? https://www.thejdm.com/forum/viewtopic.php?f=52&t=3980 |
Page 1 of 2 |
| Author: | JaySmith [ May 27, 2005 ] |
| Post subject: | Where To Cut? |
Alright I've had my ALEX Rear Strut Bar sitting here for awhile now, and I'm getting tired of looking at it. :p And I'm sure someone on here has a Civic Hatchback (EK), and had to cut the holes for it. I'm hoping someone can guide me on where to cut, maybe post pictures too? -James- |
|
| Author: | .saint [ May 27, 2005 ] |
| Post subject: | |
alot of towers come with a template. no template w/the alex bar? |
|
| Author: | JaySmith [ May 27, 2005 ] |
| Post subject: | |
Nope no template with the ALEX bar. I cry now. |
|
| Author: | JaySmith [ May 27, 2005 ] |
| Post subject: | |
Jon do you have a rear strut bar with rear interior still? I wanna find this, as my buddy can cut the holes this weekend for me.  |
|
| Author: | BRYCE [ May 27, 2005 ] |
| Post subject: | |
mabye you could try finding a template some where? |
|
| Author: | JaySmith [ May 28, 2005 ] |
| Post subject: | |
Tried, nobody has one. I was thinking maybe someone with the Mugen rear strut tower bar would have the instructions to scan, but no luck. |
|
| Author: | BRYCE [ May 28, 2005 ] |
| Post subject: | |
hmm keep lookin i am sure its out there |
|
| Author: | Bart-EK [ May 28, 2005 ] |
| Post subject: | |
dude that simple... 1. measure where the bar will run through... (there's those raised bars and you'd have to cut the hole higher... or the spoon like bars that run straight from left to right which means the hole should be a little lower) 2. check how much will go through the interiour... just the bar, or also a little bit of the 'feet' 3. stick your indexfinger into your mouth, make it wet, put it into the air and feel where the wind is coming from... and start cutting away it's not an exact science you know |
|
| Author: | Project98EK [ May 28, 2005 ] |
| Post subject: | |
hahahahahahahahahahah |
|
| Author: | neocrash [ May 28, 2005 ] |
| Post subject: | |
gonna do the cut for my alex bar this weekend. Shouldn't be that hard. |
|
| All times are UTC-04:00 | Page 1 of 2 |
|
Powered by phpBB® Forum Software © phpBB Limited |
|