thejdm.com v6 [2026 rebirth]
https://www.thejdm.com/forum/
Print view

runing rollcage bars thur rear panels
https://www.thejdm.com/forum/viewtopic.php?f=52&t=6986		 Page 1 of 2
Author:  vtjdmsir [ August 25, 2006 ]
Post subject:  runing rollcage bars thur rear panels
Im getting ready to build my cage and just wonder if any one has any tips on where to cut my panels to run the down strut bars to my rear wheel well
Author:  Sean @ NDF [ August 25, 2006 ]
Post subject: 
Im not sure I understand the question...

You mean the rear bars of the cage?
Author:  Dont Blink [ August 26, 2006 ]
Post subject: 
once the main hoop is in just get a shorter bar that will go from the main hope to the plastic and line them up where they will go, if anything this will get you close.
Author:  BRYCE [ August 28, 2006 ]
Post subject: 
cut them where they need to be cut...
Author:  vtjdmsir [ August 30, 2006 ]
Post subject: 
BRYCE wrote:cut them where they need to be cut...
thats why im try to figure out where to cut lol
Author:  BRYCE [ August 31, 2006 ]
Post subject: 
well you are the only one that knows what kinda design you are going to do for the cage... so how in a blue moon are we suppost to help you?
Author:  Nikku [ September 05, 2006 ]
Post subject: 
vtjdmsir wrote:
BRYCE wrote:cut them where they need to be cut...
thats why im try to figure out where to cut lol
fit the cage, you will see where you need to cut them.
Author:  Sean @ NDF [ September 05, 2006 ]
Post subject: 
i still dont understand this question
Author:  spnfedeg6 [ September 05, 2006 ]
Post subject: 
Dude it is going to take alot of panels be put in and out of the car. Making sure your mocking it up exactly where its going to go.... its tough and it takes some time and patience. You may have to get it close and then just open up the holes in the panels. Thats what I did in my car its not perfect but it works. Hope it helps a little.
Author:  LiAnn C. [ November 18, 2006 ]
Post subject: 
i took this from a 240 forum.... but this will help you a lot..
tokes¹ wrote:I helped my friend(redSthirteen) install an AutoPower RollBar on his s13 the other day and i took enough pictures to post the install process.

tools:
14mm socket
14mm open wrench
drill (make sure the battery is fully charged!..LoL)
100mm hole saw
jack and jack stand
silicone sealer

install time: id say about 3-5 hours. it took us alil longer because we had to sit around and let the battery charge for the drill.

remove front and rear seats... ImageImage Image now slide the rollbar inside and dry fit it.... ImageImage we had to get alil creative due to lack of tools and use a screwdriver to determine where to drill the hole in the rear panel...LoL Image now drill the holes and install the mounting bolts... Image ImageImage make sure you put some sort of silicone sealer around the bolt holes between the plates to prevent water leakage. ImageImage now put back everything that you removed and youre done!... ImageImage and they said no one could sit in the back.....LoL Image we took it for a test drive and the difference was like night and day.

thats all for now.
watch out for this car when youre out on the backroads..:2f2f: Image
All times are UTC-04:00 Page 1 of 2

Powered by phpBB® Forum Software © phpBB Limited