naw, gotta have 2 seats
and something that will run good enough until i can afford a swap. but thats bassically what im going for| thejdm.com v6 [2026 rebirth] https://www.thejdm.com/forum/ Print view |
|
| may have found an EG https://www.thejdm.com/forum/viewtopic.php?f=52&t=9021 |
Page 1 of 2 |
| Author: | tomoyasu [ August 19, 2007 ] |
| Post subject: | may have found an EG |
but i need to know what the cost is for replacing a rod bearing? anyone know? |
|
| Author: | boostjunkie95 [ August 19, 2007 ] |
| Post subject: | |
Alot if your planning on having someone do it. Chances are the crank journal is beat up from the bad bearing. Your prolly better off buying a running short block and dropping it in. |
|
| Author: | mcmBuilt [ August 19, 2007 ] |
| Post subject: | |
Exactly....Had to do it for my daily. I pulled a short block at a junk yard for $110. |
|
| Author: | tomoyasu [ August 19, 2007 ] |
| Post subject: | |
if thats the case, i'll look for something else. i plan a doing a swap so there would be no point in buying another stock engine and i wont have money for the swap right way either |
|
| Author: | .rob [ August 19, 2007 ] |
| Post subject: | |
get a dirt cheap eg. gut everything out. leave one drivers seat in. get a bride. roll cage. paint. basic automodellista shit. you're good to go. |
|
| Author: | tomoyasu [ August 19, 2007 ] |
| Post subject: | |
naw, gotta have 2 seats and something that will run good enough until i can afford a swap. but thats bassically what im going for |
|
| Author: | hondalowlow [ August 20, 2007 ] |
| Post subject: | |
get a used d15b7 there like a 100.00 at a junkyard case of beer and swap that fucker. |
|
| Author: | tomoyasu [ August 22, 2007 ] |
| Post subject: | |
found a different one...actually i found it a while ago, but thought it would be sold by now. hell of a good deal too, 92 hatch, new b18c5 with 5000 miles, clean body and interior too. he wanted $5500 a month ago... |
|
| Author: | tomoyasu [ August 23, 2007 ] |
| Post subject: | |
that other one that needed a rod bearing now says it comes with a complete short block.....not sure of what engine though..its an si too... |
|
| Author: | .rob [ August 24, 2007 ] |
| Post subject: | |
but you have no greenbacks. |
|
| All times are UTC-04:00 | Page 1 of 2 |
|
Powered by phpBB® Forum Software © phpBB Limited |
|