Banzai's General Discussion/Build up thread

SingleCamEJ8 · Post by **SingleCamEJ8** » August 28, 2006

^^^looks pimp^^^

banzai wrote:Sorry guys - Someone picked it up from my house this morning for almost twice that.

lol - If I wasn't so strapped for cash I totally would have sold it to you zero

damn....Zero lemme know if you find anything on those pieces.....well fuck i may make my own.... lol

Post by **Sean @ NDF** » August 28, 2006

'smoke a pole joel' pointed out that the switches look crooked - but they're not. The nuts are just tightened differently

Bennett @ ESG · Post by **Bennett @ ESG** » August 29, 2006

banzai wrote:'smoke a pole joel' pointed out that the switches look crooked - but they're not. The nuts are just tightened differently

hahah i gave him that nickname. Im gonna haxorz in and change the name of this thread to "Banzai's Rice Car Build"

Post by **Sean @ NDF** » August 29, 2006

try it...just try it

Post by **BRYCE** » August 29, 2006

nice, but mroe pics less talking

KSE · Post by **KSE** » August 29, 2006

BRYCE wrote:nice, but mroe pics less talking

haha werd.

Post by 77 » August 29, 2006

banzai wrote:'smoke a pole joel' pointed out that the switches look crooked - but they're not. The nuts are just tightened differently

If possible, put the panel face down on a vice, clamp the outter nuts all to the same direction (level) and tighten from the back. If that's not possible, go through the tedious chore of tightening them all individually such that they all line up. Details dude, even on a race car.

tomoyasu · Post by **tomoyasu** » August 29, 2006

banzai wrote:

hydrolics? lol

Post by **Sean @ NDF** » August 29, 2006

ToByTuNeD wrote:
banzai wrote:'smoke a pole joel' pointed out that the switches look crooked - but they're not. The nuts are just tightened differently
If possible, put the panel face down on a vice, clamp the outter nuts all to the same direction (level) and tighten from the back. If that's not possible, go through the tedious chore of tightening them all individually such that they all line up. Details dude, even on a race car.

tell me about it, I went to drill the hole for the push start today, and I put it to the right of the main ignition switch, everything was fine...but.....

i didnt like the way it looked, I want it above it.

So I ordered another 40 dollar double din block off from ICB today

Talk about details...

Post by **Sean @ NDF** » August 29, 2006

I'm gonna make a holder for anny's XM radio with the drilled out one