yeah a swap was a future plan but thats cause i dont have the cash for it right now... im not looking to build this engine internally either cause ill end up breaking something else cause of how i run it... and im assuming you mean if i build it myself its cheap... damn i wish people would barder nowadays >_<
(i prolly misspelled that too)
I'm excited to announce that thejdm is now updated to the latest phpbb 3.2 software. You may notice the site is now mobile friendly but with the upgrade comes some hiccups. theGarage, theGallery, theArcade are no longer supported. In due time the developers should be working to release the modifications to work on the new software. #LetsMakeForumsGreatAgain
why does the sohc hate me?
I just spun a rod bearing in my boosted sohc daily driver......It sucks!!!
TEAM MCM
http://WWW.BUILTMOTORSPORTSWEAR.COM
http://www.myspace.com/builtmotorsportswear
http://WWW.BDLINDUSTRIES.COM
"It's not what you say, It's what you do."
http://WWW.BUILTMOTORSPORTSWEAR.COM
http://www.myspace.com/builtmotorsportswear
http://WWW.BDLINDUSTRIES.COM
"It's not what you say, It's what you do."
-
hondalowlow
- Posts: 2662
- Joined: December 23, 2003
- Location: Homer City PA
- Contact:
no time like the present to learn. its barter btwZero wrote:yeah a swap was a future plan but thats cause i dont have the cash for it right now... im not looking to build this engine internally either cause ill end up breaking something else cause of how i run it... and im assuming you mean if i build it myself its cheap... damn i wish people would barder nowadays >_<
(i prolly misspelled that too)
. taking apart the engine and what not isnt hard, hell, no joke, i sold my friend my old b16 long block, most likely she was fine but (i never ran it), since it wasnt installed in the car yet and the head was already off the block he bought some CTR pistons/rings then went to get it rebuilt. The machine shop charged him $400 for the rebuild (new bearings, bore to .25 over, hone, install new pistons, etc). 
Just call me Dr. Vice.