I'm excited to announce that thejdm is now updated to the latest phpbb 3.2 software. You may notice the site is now mobile friendly but with the upgrade comes some hiccups. theGarage, theGallery, theArcade are no longer supported. In due time the developers should be working to release the modifications to work on the new software. #LetsMakeForumsGreatAgain
replica Varis 350z bumper intake on miata
-
SIMPLEGREEN
- 5% ricer
- Posts: 791
- Joined: December 28, 2003
- Location: DevineWind, CA.
SWEET SETUP HOW MUCH POWER DID U PUT DOWN AT THE DYNO?
Thank you to my sponsors :
SympleSpeedGarage*StreetImage*Rywire*ImportAutoPros* Function&Form*StatusRacing*ASCspeedmetal*
VibrantPerFormance*Skunk2*PLAN:B*LRautobody*
PasswordJDM*RadiumEngineering*CircuitHero*RSmachines*
BuiltMotorsportwear*RamsinEngineering*
VelocityPowdercoat*GoAutoworks*Hondata*BloxRacing*
FalkenTires*AutoFashion*HeelToeAuto*Downstar*
DefinitePowderKoat
DEVINE WIND RACING
R.I.P. JON TANJI...DOHC GARAGE LIVES ON FOREVER
It put down 260 wheel at 12psi
finally turbo!
check the cardomain!!! http://www.cardomain.com/ride/832854
check the cardomain!!! http://www.cardomain.com/ride/832854
-
SIMPLEGREEN
- 5% ricer
- Posts: 791
- Joined: December 28, 2003
- Location: DevineWind, CA.
You are a brave man, cutting up an NB. Most NB owners are too wine-and-cheese to attempt such a thing.
Are you ducting this around the rad? Hope so because it looks like it'll be just blowing on the top/driver corner of the rad unless there's some ducting.
Props for being different. I'm still wrestling with two options for mine - either creating a boxed-off area for my intake, which would require a 90* bend from the turbo and a bit of sheet aluminum, or just running the intake into the cowl. Decisions, decisions..
Are you ducting this around the rad? Hope so because it looks like it'll be just blowing on the top/driver corner of the rad unless there's some ducting.
Props for being different. I'm still wrestling with two options for mine - either creating a boxed-off area for my intake, which would require a 90* bend from the turbo and a bit of sheet aluminum, or just running the intake into the cowl. Decisions, decisions..
