I'm excited to announce that thejdm is now updated to the latest phpbb 3.2 software. You may notice the site is now mobile friendly but with the upgrade comes some hiccups. theGarage, theGallery, theArcade are no longer supported. In due time the developers should be working to release the modifications to work on the new software. #LetsMakeForumsGreatAgain
Th400 + 80mm borg warner (s380) lexus sc300 project
the old one weighted 1/3 what this one weighs (old one was aluminum)... this one looks 10x better though and will make a lot more power being 4" which will justify the weight
'93 SC300 (BW S380 / TH400 / AEM / built motor) http://www.2JZpower.com
'93 300zx Outlaw Class drag car (RB26, Liberty 5-spd, etc etc etc) http://www.Z32power.com
'93 300zx Outlaw Class drag car (RB26, Liberty 5-spd, etc etc etc) http://www.Z32power.com
- boostjunkie95
- Posts: 2728
- Joined: December 28, 2005
- Location: Revloc, PA
- Contact:
almost there:
main things need to do yet:
1. wire the coil on plug system, clean up some of the other wiring
2. wait for cam gears with hall sensor to come back from DaveH, then install timing belt etc.
3. install 1600cc injectors
4. get it tuned (not sure who to get yet)
hope to fire it up within 2 weeks
main things need to do yet:
1. wire the coil on plug system, clean up some of the other wiring
2. wait for cam gears with hall sensor to come back from DaveH, then install timing belt etc.
3. install 1600cc injectors
4. get it tuned (not sure who to get yet)
hope to fire it up within 2 weeks-
*CACKYWHEELS
- Approved Vendor
- Posts: 409
- Joined: April 07, 2007
- Contact:
still needs some wiring cleaned up:
idling video(needs timing set yet, very rough idle)
http://2jzpower.com/pictures/Joel_Grann ... I_1245.avi
got fuel pump?
http://2jzpower.com/pictures/Joel_Grann ... I_1246.avi
idling video(needs timing set yet, very rough idle)http://2jzpower.com/pictures/Joel_Grann ... I_1245.avi
got fuel pump?
http://2jzpower.com/pictures/Joel_Grann ... I_1246.avi
- boostjunkie95
- Posts: 2728
- Joined: December 28, 2005
- Location: Revloc, PA
- Contact:
