duckbill wing install

Hatcher · Post by **Hatcher** » February 02, 2004

I'm trying to take off my stock brake light spoiler so i can install a vis duckbill wing. so far i've taken out the 2 little screws where the brake light is and the 2 nuts underneath in the door jam... what do I do next? thanks

YouTube · Post by **.saint** » February 03, 2004

open the hatch and look in the center there should be a black plug. take that plug out and there is a bolt hiding under there. undo that bolt and the rest of the bolts. and it will pop right off.

Post by **tenchu** » February 03, 2004

and dont forget to post pictures when complete

iron monky · Post by **iron monky** » February 03, 2004

to install a duck bill wing you need to
a.disconnect yur factory tail light
b.undo the water plugg
c.pull of the upper center panel and reviel 2 bolts
d.unscrew the outer bolts...in total there are only 4 bolts
e. remove and place yur new duckbill on yur car

Post by **BRYCE** » February 03, 2004

f. sport it around town

Hatcher · Post by **Hatcher** » February 04, 2004

well I got it installed and the fitment turned out to be good. But now I have a couple more questions... I installed it like I said but I didnt disconnect my tail light to do it, and I didnt do anything with that plug that john mentioned. all I did was wrap electrical tape around that wire thing that goes into the little tube. and off to the right there's that little wire plug harness I diconnected that when I took off the stock one and I wrapped that in electrical tape. Is there anything I should've done differently?

iron monky · Post by **iron monky** » February 04, 2004

as long as u wrapped the wires up and there not exposued then you shoul be ok man

Hatcher · Post by **Hatcher** » March 15, 2004

next step... get a real spoon tail. I've learned my lesson with this fake shit. VIS wings suck, my friends hood has a 1/2 inch gap above his right side headlight too, I think I'll only get their c/f hatch and that's it.