Spoon tower bars.

jdm delivery · Post by **jdm delivery** » April 15, 2004

i was considering buying some Spoon tower bars. has anyone heard anything about them good/bad will the work in a coupe? thanks..

Post by **kotomile** » April 15, 2004

EG coupe? EK coupe? If they work in a hatch, I think they should work fine in the coupe.

jdm delivery · Post by **jdm delivery** » April 15, 2004

ek coupe.

Post by **BRYCE** » April 15, 2004

I would imagen they rank up there pretty high. I doubt spoon would make a shitty product.

blingin' civic · Post by **blingin' civic** » April 16, 2004

why dont you just get the Skunk2 ones and save a little cash. They are practically the same thing.

Post by **kotomile** » April 16, 2004

Good call. Skunk2 walks all over Spoon IMO. S2 is Spoon without the JDM bling.

jdm delivery · Post by **jdm delivery** » April 17, 2004

good point.

Post by **BRYCE** » April 17, 2004

ha S2 is to USDM as Spoop is to JDM

jdmwagon · Post by **jdmwagon** » April 17, 2004

the Spoon stuff is good. I have the tie bars and I like them. All out JDM=Spoon I don't give a fawk I rock what's easy=Skunk 2

Bart-EK · Post by **Bart-EK** » April 17, 2004

Sporting the Spoon stuff on my EF... Used to have shitty TenzoR crap... let me put it this way: putting the spoon ON was easier and better fitting, than the taking the Tenzo OFF...

SICK... the spoon just slid over the threads and I was done in 10 secs or so... No other BS about tightening anything else, because it's made universal or that crap... just 100% JDM precision fitment!!!