newest 2 spy photo's of goldy!

hondalowlow · Post by **hondalowlow** » June 16, 2005

jon like i stated in my post we can fix it

Post by **kotomile** » June 16, 2005

.saint wrote:im not building a trailor queen. i will be driving back and forth to shows most like alot of other show cars. a door ding wont bother me. a caved in quarter panel does.

You explain it a lot more eloquently than I.

jay-six · Post by **jay-six** » June 16, 2005

hondalowlow wrote:jon like i stated in my post we can fix it

i think he would have gotten ahold of you by now if he wanted you guys to fix it.. just my opinion tho

YouTube · Post by **.saint** » June 16, 2005

i dont have the money to get it fixed at the moment so im not rushing anything. im having burnsworth do all my work anyways.

munster · Post by **munster** » June 16, 2005

.saint wrote:i dont have the money to get it fixed at the moment so im not rushing anything. im having burnsworth do all my work anyways.

Can't go wrong with the oem body shop

YouTube · Post by **.saint** » June 17, 2005

saving has begun

fear this car in a few months!

tommybanzai · Post by **tommybanzai** » June 17, 2005

.saint wrote:saving has begun fear this car in a few months!

*yaawwwnnn* *yaawwwnnn* *yyaawwwnnnn* ... a lot of opinions flying around in this post... i lvoe ya jown, but i'm not going to suck you chopeck like some people on here....since i do know you. push the fucking dent out with you hand...or let me do it......even heat it up a little be3fore we do it, so there is a small crease line if anything... save your money....??... put a motor in it...just a motor...a good starting point... worry about getting it fixed after this winter then...or whenever... i don't care what you say, you want a motor, but you are too impatient to save for 3 months for one...or however long it takes. you end up turning around and blowing it on my JDM goodness (which is fine), but continuing to buy more and more is getting you nowhere in my mind.... i think you'd enjoy your car a whole lot more if it had some nuts below its twig....oh well...just my two cents.

1) push the dent out by hand
2) collect the insurance check
3) save the money
4) buy a motor (LS, GSR)
5) take it out on the streets and let goldy burn up her first set of tires :twisted:

YouTube · Post by **.saint** » June 17, 2005

no insurance check.

sfc · Post by **sfc** » June 17, 2005

.saint wrote:no insurance check.

I can't imagine you can't get a motor for a fuckton less than the cost of OEM doing the bodywork even without an insurance check though. Hell, I got a perfectly good b18b block for 105$ a while back. I *KNOW* you can find a b16 or b18c head to slap on there for less than 500$ easily. That's an LS/vtec for <600$, shouldn't take THAT long to save up for if you work fulltime. Hell, I have that much in my bank account right now and I'm a poor bastard.

hondalowlow · Post by **hondalowlow** » June 17, 2005

.saint wrote:no insurance check.

dude that sucks. bring it to the shop and ill have steve push it out the best he can