"New" Suspension....

Post by **JaySmith** » December 22, 2005

Just recently picked these up off a friend.

They're slightly used, but after a good "Smithers" cleaning, they're in extremely good condition. (note: the one on the far left is still uncleaned) The only real issue with them however, is the helper springs. As you can see they're rusted for some odd reason. lol

So onto my question. Can I have these helper springs sand blasted, and powder coated? I know Tein powder coats them, but I'm wondering if I have them redone by someone, if they'll just end up cracking.

munster · Post by **munster** » December 22, 2005

Nice pick up.

As far as powdercoating them...I don't know if spring manufacturers do anything different.

Post by **Sean @ NDF** » December 22, 2005

try to sand the rust off, and then maybe paint over them? nice buy!

Post by **JaySmith** » December 22, 2005

Thanks guys. Should be an enjoyable summer.

I might even purchase Teins upgradable springs for them, so I can run 16k front, 12k rear.