I'm excited to announce that thejdm is now updated to the latest phpbb 3.2 software. You may notice the site is now mobile friendly but with the upgrade comes some hiccups. theGarage, theGallery, theArcade are no longer supported. In due time the developers should be working to release the modifications to work on the new software. #LetsMakeForumsGreatAgain

Low RPM hesitation

engine. drivetrain. engine management & trouble codes talk.
Post Reply
spnfedeg6
65% ricer
Posts: 318
Joined: September 19, 2004
Location: pittsburgh

just a miss

Post by spnfedeg6 » November 29, 2004

Do a tune up plugs, wires, cap, rotor, and fuel filter wont hurt. Definitely not vacuum trust me you would have horrible idle probs if it was.
Top
C.R.X
95% ricer
Posts: 54
Joined: December 11, 2003

Post by C.R.X » December 01, 2004

basic tune would help- however, is this a swap vehicle?

if so,
I would check for cel codes
distributor wires (1 missing thread for crank sensor can cause this, it happended to me)
reset ecu
test fuel pressure, inline and out of the fuel filter.
and yes, definitely, I would do a fuel filter change.

good luck bro.
Top
User avatar
munster
Posts: 10705
Joined: January 31, 2003
Location: Somewhere between Heaven and Hell.

Post by munster » December 01, 2004

It's taken care of...a long time ago. I don't know which it was, but a simple tune up took care of it.
Built Motorsportswear - Function/Form Autolife - ICB Motorsports
Go Autoworks - K-Tuned - My friends
Top
ban
95% ricer
Posts: 69
Joined: August 11, 2003
Location: johnstown
Contact:
Contact ban

Post by ban » December 08, 2004

guarantee it was the filter. injectors are a rare occasion.. considering u didn't have a mis just a hesitation.
no comment
Top
BRYCE
Posts: 5323
Joined: January 18, 2004
Location: Twin Cities, MN
Contact:
Contact BRYCE

Post by BRYCE » December 09, 2004

mabye its your muffler bearings?
AE86 Levin Coupe x SR20DET x Watanabe R-Type
Bryce
Top
User avatar
munster
Posts: 10705
Joined: January 31, 2003
Location: Somewhere between Heaven and Hell.

Post by munster » December 09, 2004

Actually I changed the turn signal fluid and it was good as new.
Top
BRYCE
Posts: 5323
Joined: January 18, 2004
Location: Twin Cities, MN
Contact:
Contact BRYCE

Post by BRYCE » December 09, 2004

oh snap i am out of suggestions
Top
sfc
15% ricer
Posts: 685
Joined: November 11, 2003

Post by sfc » December 09, 2004

you should just slap some roller rockers in there and it'd gain at least 50whp.
Image
Top
Post Reply

Return to “general tech”